3M™ motor lead in-line splicing kits 5300 series are designed for splicing motor lead cables to incoming feeder cables. 3M™ motor lead splicing kits 5331-5334 can accommodate in-line connections, 5/8 kV shielded and non-shielded feeders. The splices main component, the slip-on splice cover is made from EPDM rubber. A mastic strip is used for the moisture seal on the inline kits. These kits are designed to be used with copper compression, 1 or 2-hole lugs. after being crimped onto the cables, the lugs are bolted together in an inline configuration, then insulated and sealed with the 3M™ motor lead splicing kits. Each kit contains all the necessary materials (except lugs) needed to make three splices. The lugs must be purchased separately. 3M™ Scotchlok™ 30000 series copper compression lugs or other UL listed copper lugs, can be used. In addition, 3M™ motor lead splicing kits 5331-5334 require vinyl tape which can also be purchased separately. For in-line splice kits the longitudinal space required for assembly will be approximately 2 (splice cover length), to allow space for the splice while the connection is being made.